I decided on a mini one as I have no need to cut huge bits of wood currently I need to cut a lot of 13mm thick pine wood at various angles to place on walls.
1st one I purchased was from Toolstation by draper it was 600w and cut to 27mm depth.
It looked to be what I needed, it didn't say if it did angled cuts bit it said max depth at 90 degrees so I purchased it.
On opening the box I found this plunge saw to just cut straight cuts and allowed various depths so it was no good for what I intend to use it for.
I looked on Amazon and found the worx Wa429 it cuts deeper 46mm, can plunge and will cut to a 45 degree angle, video on the link. My only concern is it is 400watt and less rpm than the draper so it could stall when cutting.
It arrived Saturday in a sturdy looking hinged plastic box.
Out the box it looks nice and felt quite light
This is the back side where you can set the blade depth you require
This is the front where you can set your blade angle
These are the steel blade and the ceramic blade
I had a quick go at cutting up some old wood at 45 degree angles and here it is not yo bad for a quick go
No comments:
Post a Comment